![]() | ![]() |
![]() | ![]() |
![]() | ![]() |
CXLE8945 CXLE8946 is used to drive a LED string (<60V), and remove the 100/120Hz current ripple on AC/DC power by a capacitor between VC and GND. CXLE8945 allows user to setup the maximum voltage on LED pin by connect a resistor between VLMT and GND. If the voltage on LED pin exceeds limit threshold, the current ripple remover is disabled and remain the LED voltage, which could help limiting the power dissipation on chip. Multiple JCXLE8945 can operate in parallel by shorting all VC PINs together. The average current matching rate between each JCXLE8945 is less than ±1%. The maximum LED current is internally limited as 440mA. JCXLE8945provides thermal protection
Scalable Adaptive 100/120Hz Current Ripple
Remover
5V~60V Input Voltage
Built-in LED Driving MOSFET
LED Voltage Low to 0.65V @ 0.25A
Programmable LED Current Ripple
Programmable maximum LED Voltage
Over thermal protection
eSOP8 and TO220-5L package
LED Lighting
需要详细的PDF规格书请扫一扫微信联系我们,还可以获得免费样品以及技术支持!
工频纹波滤除产品 | ||||||
产品型号 | 描述 | LED 电压 | 最大输出电流(A) | 功率管 | 封装 | OCP,OVP,和OTP |
自适应100/120Hz 电流纹波消除IC | 4.5 - 60 | 0.35 | 内置 | ESOP8 TO220-5 | Latch-off | |
自适应100/120Hz 电流纹波消除IC(适用于Triac 调光) | 5 - 60 | 0.6 | 内置 | ESOP8 | Hiccup | |
自适应100/120Hz 电流纹波消除IC | 10 - 60 | 1 | 内置 | TO252-5 | Hiccup | |
自适应100/120Hz 电流纹波消除IC | 10 - 60 | 0.5 | 内置 | ESOP8 | Hiccup | |
集成高压MOS的自适应100/120Hz电流纹波消除IC | 12-130 | 0.5 | 内置 | ESOP8 | Hiccup | |
自适应100/120Hz 电流纹波消除控制器 | Up to 200V | Up to 5A | 外置 | SOT23-6 | Hiccup |