Integrated Multi-Channel DC-DC Converter for TFT-LCD Panels CXLC8995/A includes a high-performance boost regulator, a low dropout linear regulator (LDO), a gate pulse modulator (GPM)

   产品概述 返回TOPjVC嘉泰姆

The CXLC8995/A includes a high-performance boost regulator, a low dropout linear regulator (LDO), a gate pulse modulator (GPM), a voltage detector, a VCOM buffer (unity-gain OPA), and a VGH charge pump controller for activematrix thin-film transistor (TFT) liquid-crystal displays (LCDs). The boost converter provides the regulated supply voltage for the panel source driver ICs. The converter is a high switching frequency (640kHz or 1.2MHz) currentmode regulator with an integrated 20V N-Channel 0.2Ω MOSFET that allows the use of ultra-small inductors and ceramic capacitors. It provides fast transient response to pulsed loading while achieving efficiency over 90%. The device can produce output voltage as high as 18V from an input as low as 2.8V. Soft-Start is programmed by external capacitor, which sets the input-current ramp-rate. The low-dropout (LDO) linear regulator can supply up to 350mA current while input voltage is 3.3V. It uses an internal PMOS as the pass device. It is suitable for the supply voltage of the timing controller. The GPM is controlled by frame signals from timing controller to modulate the Gate-On voltage, VGHM, which acts a flicker compensation circuit to reduce the coupling effect between gate lines and pixels. It also can delay the Gate-On voltage while power-on for achieving a corrected power-on sequence for gate driver ICs. Both of power-on delay time and the falling time of the Gate-On voltage are programmable by external capacitor and resistor. The voltage detector monitors the supply voltage to issue a reset signal while the detected voltage is too low. The detecting level is decided by an external resistor divider and the delay time is programmable by an external capacitor. The VCOM buffer can drive the LCD VCOM voltage that features high short-circuit current (150mA), fast slew rate (12V/μs), wide bandwidth (12MHz) and rail-to-rail input/output. The VGH charge pump controller provides regulated TFT Gate-On voltage. The regulation of the positive charge pump is generated by the internal comparator that senses the output voltage and compares it with an internal reference.

   产品特点 返回TOPjVC嘉泰姆

„ 2.5V to 5.5V Input Supply Range jVC嘉泰姆

„ 640kHz/1.2MHz Current-Mode Boost Regulator jVC嘉泰姆

Š Fast Transient Response to Pulse Load jVC嘉泰姆

Š ±1% Accurate Output Voltage jVC嘉泰姆

Š Built-In 20V/2A, 0.2Ω N-Channel MOSFET jVC嘉泰姆

Š High Efficiency up to 90% jVC嘉泰姆

Š Programmable Soft-Start jVC嘉泰姆

Š Over-Current Protection jVC嘉泰姆

Š Output Under-Voltage Protection jVC嘉泰姆

„ High-Performance Operational Amplifiers ±150mA Output Short-Circuit Current jVC嘉泰姆

Š 12V/μs Slew Rate jVC嘉泰姆

Š 12MHz, -3dB Bandwidth jVC嘉泰姆

Š Rail-to-Rail Input and Output jVC嘉泰姆

„ Low Dropout Voltage Linear Regulator jVC嘉泰姆

Š 350mA Maximum Output Current jVC嘉泰姆

Š Adjustable Output Voltage jVC嘉泰姆

„ On-Chip GPM Controller jVC嘉泰姆

Š Adjustable Falling Time and Power-On Delay jVC嘉泰姆

Š Flicker Compensator jVC嘉泰姆

Š Power-On Sequence Control jVC嘉泰姆

„ Charge pump for VGH regulation jVC嘉泰姆

„ Low Voltage Detector jVC嘉泰姆

 Š Programmable Detecting Voltage and Delay Time jVC嘉泰姆

„ Thermal-Overload Protection jVC嘉泰姆

„ RoHs Compliant jVC嘉泰姆

„ TQFN4X4-24 PackagejVC嘉泰姆

   应用范围 返回TOPjVC嘉泰姆

„ LCD Monitor jVC嘉泰姆

„ Notebook Computer Displays jVC嘉泰姆

„ LCD TVsjVC嘉泰姆

   技术规格书（产品PDF) 返回TOP jVC嘉泰姆

     需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！jVC嘉泰姆