CXPC3346同步buck是高效的单片同步buck稳压器采用恒定频率电流模式结构轻载高效PFM模式励磁涌流限制及软起动每个通道输出电流为0.5A输入电压2-6V 输出电压1.2V~4.5V
| 产品型号: | CXPC3346 |
| 产品类型: | 通用MCU |
| 产品系列: | PMU |
| 产品状态: | 量产 |
| 浏览次数: | 47 次 |
产品简介
CXPC3346是一个功率管理单元(PMU),具有1个同步降压和2个CMOS低损耗稳压器,为降压输出提供1.5A的最大电流,为每个LDO的输出提供0.5A的最大电流。同步buck是一种高效的单片同步buck稳压器,采用恒定频率、电流模式结构。该设备有可调版本。空载供电电流为40uA,停机时降至<1uA。2.5V至6V的输入电压范围使CXPC3346非常适合单锂离子电池供电的应用。100%占空比提供低漏失操作,延长便携式系统的电池寿命。PWM/PFM模式操作为噪声敏感应用提供非常低的输出纹波电压。开关频率内部设置为1.5MHz,允许使用小型表面贴装电感和电容器。低输出电压很容易支持与0.6V反馈参考电压。
两个LDO都是低电压降稳压器,最大输出电流为0.5A。在0.5A负载电流下的典型漏失电压为0.8V,具有良好的负载和线路暂态响应,良好的温度特性,可以保证芯片和电力系统的稳定性。通过微调,每个通道的输出精度设置在2%以内。典型的LDO输出电压:VO1=2.8V,VO2=1.8V。每0.1V步进可提供1.2V~4.5V范围内的其它固定电压。它也可以根据命令定制。LDOs还可以在2V到6V的宽输入电压下工作,并提供折叠短路保护和输出限流功能。
高效:高达96%
可提供1.5A
1.5MHz开关频率
不需要外部肖特基二极管
低辍学率100%工作
轻载高效PFM模式
过热保护
低静态电流:40μA
短路保护
励磁涌流限制及软起动
LDO公司
每个通道的最大输出电流为0.5A
输入电压范围:2-6V
输出电压范围:1.2V~4.5V(每0.1V步按指令定制)
低功耗:40uA(典型)
低输出噪声(47uVRMS)
低压差:
600毫伏,IO1=500毫安,VO1=2.8伏
IO2=500mA时800mV,VO2=1.8V
高纹波抑制:65dB@1KHz(典型)
低温系数:±100ppm/℃
优良线路调节率:0.05%/V
高精度:±2%
输出电流限制
折回短路电流
技术参数
| 输入电压范围 (VIN) | ≤ Buck 6V; LDO 6VV |
|---|
| 输出电压 (VOUT) | ADJV |
|---|
| 输出电流 (IOUT) | DC/DC: 1.5A LDO: 0.5AA |
|---|
| 工作频率 | 1.5MHzHz |
|---|
| 转换效率 | 95%% |
|---|
| 封装类型 | ESOP8 |
|---|
| Core | 脉宽调制控制器 |
|---|
| Main frequency | 300KHZ |
|---|
| Flash Flash | 512K |
|---|
| Ram RAM | 512K |
|---|
| Peripherals | 并行/SPI/I2C |
|---|
| Operating temp | -40℃~125℃ |
|---|
| 保护功能 | 过流/过热/欠压/短路/过温 |
|---|
| 精度 | ±1% |
|---|
| Power consumption | 3uA |
|---|
| Features | 高精度/低功耗/高稳定性 |
|---|
| Application | PWM Controller(脉宽调制控制器) |
|---|
产品详细介绍
产品概述
The CXPC3346 is a power management unit (PMU), with 1 synchronous Buck and 2 CMOS low-dropout regulators that delivers a maximum current of 1.5A for Buck’s output and a maximum current of 0.5A for each individual LDO’s output.
The synchronous buck is a high-efficiency monolithic synchronous buck regulator using a constant frequency, current mode architecture. The device is available in an adjustable version. Supply current with no load is 40uA and drops to <1uA in shutdown. The 2.5V to 6V input voltage range makes the CXPC3346 ideally suited for single Li-Ion battery powered applications. 100% duty cycle provides low dropout operation, extending battery life in portable systems. PWM/PFM mode operation provides very low output ripple voltage for noise sensitive applications. Switching frequency is internally set at 1.5MHz, allowing the use of small surface mount inductors and capacitors. Low output voltages are easily supported with the 0.6V feedback reference voltage.
Each of the 2 LDOs is low-dropout regulator that delivers a maximum current of 0.5A individual output. Typical dropout voltage at 0.5A load current is 0.8V. They have excellent load and line transient response and good temperature characteristics, which can assure the stability of chip and power system. The output accuracy of each channel is set within 2% by trimming.
Typical LDO output voltage: VO1=2.8V, VO2=1.8V.
Other fixed voltage can be provided in the range of 1.2V~4.5V every 0.1V step. It also can be customized on command. LDOs can also work under a wide input voltage ranging from 2V to 6V. They can provide foldback short-circuit protection and output current limit function.
CXPC3346 is available in lead (Pb)-free ESOP-8(with exposed pad for heat dissipation) package.
产品特点 返回TOP
High Efficiency : Up to 96%
Capable of Delivering 1.5A
1.5MHz Switching Frequency
No External Schottky Diode Needed
Low dropout 100% Duty operation
PFM Mode for High Efficiency in Light Load
Over temperature Protected
Low Quiescent Current: 40μA
Short Circuit Protection
Inrush Current Limit and Soft Start
LDO
Max output current for each channel is 0.5A
Input voltage range: 2 – 6V
Output voltage range: 1.2V~4.5V (customized on command every 0.1V step)
Low power consumption: 40uA (Typ.)
Low output noise (47uVRMS)
Low dropout voltage:
600mV@IO1=500mA, VO1=2.8V
800mV@IO2=500mA, VO2=1.8V
High ripple rejection:65dB@1KHz (Typ.)
Low temperature coefficient: ±100ppm/C
Excellent line regulation: 0.05%/V
Highly accurate: ±2%
Output current limit
Fold-back short circuit current
应用范围 返回TOP
Distributed Power Systems
Digital Set Top Boxes
Flat Panel Television and Monitors
Wireless and DSL Modems
Power source for cellular phones and various kind of PCSs
Battery Powered equipment
技术规格书(产品PDF) 返回TOP
需要详细的PDF规格书请扫一扫微信联系我们,还可以获得免费样品以及技术支持!


产品封装图 返回TOP

电路原理图 返回TOP

相关芯片选择指南 返回TOP
| 电源管理单元,可定制(PMU) |
| Part No. |
Configuration |
MODE |
VIN |
IQ |
FOSC |
Eff. |
FB Voltage |
IOUT |
Package |
| CXPC3343/B |
1x 1A Sync Buck 2x 1A LDO |
PWM/PFM |
Buck 7V; LDO 12V |
Buck 50μA, LDO 2mA |
1.5MHz |
97% |
0.6V |
DC/DC: 1A LDO: 1A |
DFN3x3-12L |
| CXPC3344 |
1 x 18V/2A Buck 1 x 6V/1.5A LDO |
PWM/PFM |
Buck 18V; LDO 6V |
Buck 0.8mA, LDO 100μA |
500KHz |
96% |
0.8V |
DC/DC: 2A LDO: 1.5A |
ESOP8 DFN2x3-8 |
| CXPC3345 |
1 x 18V/2A Buck 2 x 6V/1.5A LDO |
PWM/PFM |
Buck 18V; LDO 6V |
Buck 0.8mA, LDO 100μA |
500KHz |
96% |
0.8V |
DC/DC: 2A LDO: 1.5A |
DFN3x3-12 |
| CXPC3346 |
1 x 6V/1.5A Buck 2 x 6V/0.5A LDO |
PWM/PFM |
Buck 6V; LDO 6V |
Buck 40μA, LDO 35μA |
1.5MHz |
96% |
0.6V |
DC/DC: 1.5A LDO: 0.5A |
ESOP8 |
| CXPC3347 |
1 x 7V/1A Buck 1 x 6V/0.5A LDO |
PWM/PFM |
Buck 7V; LDO 6V |
Buck 50μA, LDO 35μA |
1.5MHz |
97% |
0.6V |
DC/DC: 1A LDO: 0.5A |
DFN2x2-8 |
| CXPC3348 |
2 x 6V/1.5A Buck 2 x 6V/0.5A LDO |
PWM/PFM |
Buck 6V; LDO 6V |
Buck 40μA, LDO 35μA |
1.5MHz |
96% |
0.6V |
DC/DC: 1.5A LDO: 0.5A |
QFN3x3-16 |
用户评论