CXLB7374结合了开关模式电池充电器和一个具有固定3MHz开关频率的升压调节器,后者驱动两个集成N通道功率mosfet。在电池充电中,高效降压型DC/DC转换器能够在4伏到6伏的宽输入电压范围内为CXLB7374提供1.5安的输出电流,降压型DC/DC转换器非常适合由1芯锂离子电池供电的便携式电子设备。充电参数和工作模式可通过I2C接口编程。CXLB7374具有高精度的输入电流、充电电流和充电电压调节。它配有充电终端和充电状态监测,用于电池检测。CXLB7374将蓄电池充电分为三个阶段:调节、恒流和恒压。CXLB7374采用动态电源管理(DPM)模式来完成输入功率限制。输入电流限制为I2C主机设置的值。当达到输入功率限制时,此功能可降低电池充电电流,以避免在同时为负载和电池充电器供电时使交流适配器过载。充电终止基于电池电压、编程的最小电流水平和由I 2C主机设置的充电电流终止位。如果蓄电池电压低于内部阈值,CXLB7374将自动重新启动充电循环,当输入电压低于蓄电池电压时,它将进入低静态电流睡眠模式。CXLB7374支持热调节和过温保护,通过降低充电电流来保持120℃的结温。CXLB7374可以作为增压调节器工作。为了支持USB OTG设备,CXLB7374可以通过提高电池电压来提供VBU(5.05V)。
-
"
目录
7.相关产品
产品概述 返回TOP
The CXLB7374 combine switch-mode battery charger and a boost regulator with fixed 3MHz switching frequency, which drives two integrated N-channel power MOSFETs. In battery charging, the high-efficiency step-down DC/DC converter is capable of delivering 1.5A output current over a wide input voltage range from 4V to 6V for CXLB7374, the step-down DC/DC converter is ideally suited for portable electronic devices that are powered from 1-cell Li-ion battery. The Charging parameters and operating modes can be programmed through an I 2C interface. The CXLB7374 has high accuracy regulation of input current, charge current and charge voltage. It equipped with charge termination, and charge status monitoring for battery detection. The CXLB7374charge the battery in three phases: conditioning, constant current and constant voltage. The CXLB7374features Dynamic Power Management (DPM) mode to accomplish input power limiting. The input current is limited to the value set by the I 2C host. This feature reduces battery charge current when the input power limit is reached to avoid overloading the AC adapter when supplying the load and the battery charger simultaneously. The charge termination is based on battery voltage, a programmed minimum current level and charge current termination bit set by the I 2C host. If the battery voltage falls below an internal threshold, the CXLB7374automatically restarts the charge cycle, and when the input voltage falls below the battery voltage, it will enter a low-quiescent current sleep mode. The CXLB7374supports the thermal regulation and over temperature protection to maintain the junction temperature of 120 oC by reducing charge current. The CXLB7374can operate as a boost regulator. To support USB OTG device, CXLB7374can provide VBUS (5.05V) by boosting the battery voltage. The CXLB7374is available in1.7mmx2.1mm WLCSP-20 and TQFN4x4-20A packages.
产品特点 返回TOP
· Charge Faster Than Linear Charger
· 3MHz with 0% to 99.5% Duty Cycle Synchronous Switch-Mode Charger with 1.5A Integrated NMOSFETs
· 4V-6V Input Operating Range
· 20V Absolute Maximum Input Voltage
· Safety -Reverse leakage protection to prevent battery drainage
-Thermal regulation and protection
-Input/output over-voltage protection
-Cycle-by-cycle current limit
· Accuracy
-+1% charge voltage regulation (0 to 85oC)
-+5% charge current regulation
-+5% input current regulation (100mA and 500mA)
· Built-In Input Current Sensing and Limiting
· Automatic Charging
· Programmable Through High-Speed I2C Interface(3.4Mb/s)
-Input Current Limit
-Fast-Charge and Termination Current
-Charge Regulation Voltage
-Weak Battery Voltage Threshold
-VIN DPM Threshold
-Termination Enable/Disable
-OTG Enable/Disable
-Reset All Parameter Control
-Safety Timer with Reset Control
· 5V, 500mA Boost Mode for USB OTG for 2.5V to 4.5V Battery Input
· Available in 1.7mmx2.1mm WLCSP-20 and TQFN4x4-20A Packages
应用范围 返回TOP
· Cell Phones, Smart Phones and PDAs
· Tablet PC
· Portable Media Players, Handheld Device
技术规格书(产品PDF) 返回TOP
需要详细的PDF规格书请扫一扫微信联系我们,还可以获得免费样品以及技术支持!
产品封装图 返回TOP
电路原理图 返回TOP
相关芯片选择指南 返回TOP 更多同类产品......
Battery Charger > Switching Chargers |
||||||||||||
Part_No |
Package |
Topology |
#of PWM Outputs |
Drive Lout (A) |
Vin (V) |
Fmax Khz |
SYNC ASYNC |
VBUS_PMID RDS(ON) milohm |
R-Top milohm |
R-Sync milohm |
Iq(no load) (uA) |
|
min |
max |
|||||||||||
WLCSP1.7x2.1-20/TQFN4x4-20A |
Buck |
1 |
1 |
4 |
6 |
3000 |
SYNC |
180/220 |
130/170 |
150/190 |
63 |