• [ CXLB73120 ]"

产品订购

目录

1.产品概述       2.产品特点     9wQ嘉泰姆

3.应用范围       4.技术规格书下载（PDF文档）9wQ嘉泰姆

5.产品封装       6.电路原理图  9wQ嘉泰姆

7.相关产品9wQ嘉泰姆

   产品概述 返回TOP9wQ嘉泰姆

     CXLB73120是一款完整的采用恒定电流/恒定电压的单节锂离子电池线性充电器。其底部带有散热片的PSOP8封装与较少的外部元件数目使得CXLB73120成为便携式应用的理想选择。CXLB73120可以适合USB电源和适配器电源工作。由于采用了内部PMOSFET架构，加上防倒充电路，所以不需要外部隔离二极管。热反馈可对充电电流进行自动调节，以便在大功率操作或高环境温度条件下对芯片温度加以限制。充饱电压固定于4.3V. 而充电电流可通过一个电阻器进行外部设置。当电池电压达到充饱电压时，充电电流逐渐下降，当充电电流后降至设定值1/10时，CXLB73120将自动终止充电过程当输入电压（交流适配器或USB电源）被拿掉时，CXLB73120自动进入一个低电流状态，将电池漏电流降至1uA以下。CXLB73120在有电源时也可置于停机模式，从而将供电电流降至30uA。CXLB73120的其他特点包括电池温度检测、欠压闭锁、自动再充电和两个用于指示充电、结束的LED 状态引脚。

CXLB73120 is a complete constant-current & constant voltage linear charger for single cell lithium-ion and Lithium-Polymer batteries.  Its SOT-23 package and low external component count make CXLB73120 ideally suited for portable applications.  Furthermore, the CXLB73120 is specifically designed to work within USB power specification.  At the same time, CXLB73120 can also be used in the standalone lithium-ion and Lithium-polymer battery chargers. No external sense resistor is needed, and no blocking diode is required due to the internal MOSFET architecture.  Thermal feedback regulates the charge current to limit the die temperature during high power operation or high ambient temperature.  The charge voltage is fixed at 4.3V, and the charge current can be programmed externally with a single resistor.  The CXLB73120 automatically terminates the charge cycle when the charge current drops to 1/10th the programmed value after the final float voltage is reached.  When the input supply (wall adapter or USB supply) is removed, the CXLB73120 automatically enters a low current stage, dropping the battery drain current to less than 2uA.  The CXLB73120 can be put into shutdown mode, reducing the supply current to 20uA. Other features include charge current monitor, undervoltage lockout, automatic recharge and a status pin to indicate charge termination and the presence of an input voltage. CXLB73120 is intentionally designed to have slightly negative Tempco. This provides extra protection to Lithium battery during charging

   产品特点 返回TOP9wQ嘉泰姆

高达1000mA的可编程充电电流 9wQ嘉泰姆

n 无需MOSFET、检测电阻器或隔离二极管 9wQ嘉泰姆

n 用于单节锂离子电池的完整线性充电器 9wQ嘉泰姆

n 恒定电流/恒定电压操作，并具有可在无过热危险的情况下实现充电速率最大化的热调节功能 9wQ嘉泰姆

n 精度达到±%的4.3V预设充饱电压 9wQ嘉泰姆

n 电池电量检测的充电电流监控器输出 9wQ嘉泰姆

n 自动再充电 9wQ嘉泰姆

n 充电状态双输出、无电池和故障状态显示 9wQ嘉泰姆

n C/10 充电终止。 9wQ嘉泰姆

n 待机模式下的供电电流为70uA n 2.9V涓流充电 9wQ嘉泰姆

n 软启动限制了浪涌电流 9wQ嘉泰姆

n 电池温度监测功能 9wQ嘉泰姆

n 采用PSOP8封装9wQ嘉泰姆

¾ Programmable Charge Current Up to 800mA. 9wQ嘉泰姆

¾ No MOSFET, Sense Resistor or Blocking Diode Required. 9wQ嘉泰姆

¾ Constant-Current/Constant-Voltage Operation with Thermal Protection to Maximize Charge Rate without Risk of Overheating. 9wQ嘉泰姆

¾ Charges Single Cell Li-Ion Batteries Directly from USB Port. 9wQ嘉泰姆

¾ Preset 4.3V Charge Voltage. 9wQ嘉泰姆

¾ 20uA Supply Current in Shutdown.9wQ嘉泰姆

 ¾ 2.9V Trickle Charge Threshold 9wQ嘉泰姆

¾ Soft-Start Limits Inrush Current. 9wQ嘉泰姆

¾ Available in 5-Lead SOT-23 Package. 9wQ嘉泰姆

¾ 100% Lead (Pb)-Free9wQ嘉泰姆

   应用范围 返回TOP9wQ嘉泰姆

备用电源/移动电源 9wQ嘉泰姆

n 移动电话、PDA、GPS n MP3、MP4播放器 9wQ嘉泰姆

n 数码相机、电子词典 9wQ嘉泰姆

 便携式设备、各种充电器9wQ嘉泰姆

¾ Cellular Telephones, PDA’s, MP3 Players. 9wQ嘉泰姆

¾ Charging Docks and Cradles 9wQ嘉泰姆

¾ Bluetooth Applications 9wQ嘉泰姆

   技术规格书（产品PDF) 返回TOP 9wQ嘉泰姆

     需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！9wQ嘉泰姆

 9wQ嘉泰姆

产品封装图 返回TOP9wQ嘉泰姆

9wQ嘉泰姆

9wQ嘉泰姆

电路原理图 返回TOP9wQ嘉泰姆

 9wQ嘉泰姆

 9wQ嘉泰姆

9wQ嘉泰姆

相关芯片选择指南 返回TOP                         更多同类产品......

 9wQ嘉泰姆

◀ 上一篇:CXLB73118高效率高频率同步降压直流直流监管机构IC电流限制和软启动1.5A输出电流输入电压2.3v至5.5v控制良好的线和负载瞬态响应短路保护

返回顶部

下一篇▶:可编程充电电流800毫安CXLB73121软启动限制励磁涌流2.9V涓流充电阈值USB端口单电池锂离子和锂聚合物电池的完整恒流恒压线性充电器自动终止充电循环