CXSD62362型PWM控制器采用恒导通控制方案，可以方便地处理宽的输入/输出电压比，在保持相对恒定的开关频率的同时，对负载瞬态提供100ns的“瞬时通”响应。CXSD62362A/CXSD62362通过消除传统电流模式PWMs中的电流感应电阻，以较低的成本实现了高效率。驱动超大同步整流mosfet的能力进一步提高了效率。单级降压转换允许这些设备直接降压高压电池，以获得尽可能高的效率。
-
"
目录
7.相关产品
产品概述 返回TOP
CXSD62362A/CXSD62362B PWM controller uses constant on-time control scheme to handle wide input/output voltage ratios with ease and provides 100ns “instant-on” response to load transients while maintaining a relatively constant switching frequency. The CXSD62362A/CXSD62362 achieves high efficiency at a reduced cost by eliminating the current-sense resistor found in traditional current-mode PWMs. Efficiency is further enhanced by an ability to drive very large synchronous rectifier MOSFETs. Single-stage buck conversion allows these devices to directly step down high-voltage batteries for the highest possible efficiency. Alternatively, two-stage conversion (stepping down the +5V system supply instead of the battery) at a higher switching frequency allows the minimum possible physical size. The CXSD62362/CXSD62362 is intended for CPU core, chipset, DRAM, or other low-voltage supplies as low as 0.75V. It provides four resistor-programmable output voltages by G0 and G1 digital inputs. The CXSD62362/CXSD62362 is available in 16-pin TQFN (3X3) package.
产品特点 返回TOP
„ Ultra-High Efficiency
„ No Current-Sense Resistor (Lossless ILIMIT)
„ Quasi-PWM with 100ns Load-Step Response
„ 1% VOUT Accuracy Over Line and Load
„ 0.75V to 3.6V Adjustable Output Range
„ Dynamic Voltage Scaling by G0 and G1 Inputs
„ 4.5V to 24V Battery Input Range
„ OVP & UVP
„ Built-in BST Diode
„ 1.7ms Soft-Start
„ Drives Large Synchronous-Rectifier FETs
„ Power-Good Indicator
„ G0/G1 High Active (CXSD62362A) G0/G1 Low Active (CXSD62362B)
应用范围 返回TOP
„ Notebook Computers
„ CPU Core Supply
„ Chipset/RAM Supply as Low as 0.75V
„ 1.8V and 2.5V I/O Supply
„ Networking Power Supply
技术规格书（产品PDF) 返回TOP
需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！
产品封装图 返回TOP
电路原理图 返回TOP
a
相关芯片选择指南 返回TOP 更多同类产品......
|
Synchronous (Quasi-PWM) Step Down Controller |
|||||||
|
Part NO. |
Vin(V) min. |
Vin(V) max. |
VOUT (V) |
FSW (k Hz) |
FB (V) |
Note |
Package |
|
3 |
28 |
0.7~1.8 |
300/400 |
0.8 |
EN, SS, PGOOD, OVP, UVP, OCP, VTTREF, Built-in BST diode, DDR1/2/3/3L, 2A LDO for VTT |
TQFN3X3-20 |
|
|
4.5 |
28 |
0.7~2.6 |
ADJ |
0.7 |
EN, PGOOD, OVP, UVP, OCP, VOUT Adjustable,1.5ms VOUT Servo Soft Start, 4700ppm/°C RON Coefficient |
TDFN3X3-10 |
|
|
4.5 |
28 |
0.5~3.3 |
ADJ |
0.5 |
EN, PGOOD, OVP, UVP, OCP, VOUT Adjustable, 1.5ms VOUT Servo Soft Start, 4700ppm/°C RON Coefficient |
TQFN2X2-12 |
|
|
4.5 |
24 |
0.75~3.6 |
ADJ |
0.75 |
EN, SS, PGOOD, OVP, UVP, OCP, Built-in BST diode |
TQFN3X3-16 |
|
|
4.5 |
24 |
0.75~3.6 |
ADJ |
0.75 |
EN, SS, PGOOD, OVP, UVP, OCP, Built-in BST diode |
TQFN3X3-16 |
|
|
4.5 |
24 |
0.75~3.6 |
ADJ |
0.75 |
EN, SS, PGOOD, OVP, UVP, OCP, Built-in BST diode |
TQFN3X3-16/TQFN3.5X3.5-14 |
|
|
2 |
24 |
0.75~3.6 |
400/ADJ |
0.75 |
EN, SS, PGOOD, OVP, UVP, OCP, VTTREF, Built-in BST diode, DDR1/2/3/3L, 3A/2A LDO for VTT |
TQFN4X4-24/TQFN3X3-20 |
|
|
4.5 |
24 |
0.75~3.6 |
ADJ |
0.75 |
EN, PGOOD, OVP, UVP, OCP, Built-in BST diode, SS, G0 & G1 Controls VOUT |
TQFN3X3-16 |
|
