CXAR41277是一款立体声音频功率放大器，采用20针TSSOP热敏垫封装或20针TQFN 4X4。在5V电源电压下，以桥连负载（BTL）模式将2W连续均方根功率驱动至每通道4Ω负载。在上述操作条件下，其THD小于1%。为了简化笔记本电脑应用中的音频系统设计并提高驱动功率，CXAR41277支持桥接负载（BTL）模式驱动扬声器。对于低电流消耗的应用程序，支持SHDN模式在CXAR41277空闲时禁用它。电流消耗可以降低到150μA（通常）。放大器增益由两个终端（GAIN0，GAIN1）内部配置和控制。提供6dB、10dB、15.6dB、21.6dB的BTL增益设置。
“内部增益控制，消除外部增益设置电阻”集成的Depop电路
·1%THD+N时的输出功率，VDD=5V
--2.0W/CH（典型）到4Ω负载
--1.2W/CH（典型）进入8Ω负载
支撑桥梁捆绑荷载（BTL）
·全差分输入
·关闭控制可用
表面贴装电源包
-
[ CXAR41277 ]
目录
7.相关产品
产品概述 返回TOP
CXAR41277 is a stereo audio power amplifier in 20pin TSSOP thermal pad package or 20-pin TQFN 4X4. It can drive 2W continuous RMS power into 4Ω load per channel in Bridge-Tied Load (BTL) mode at 5V supply voltage. Its THD is smaller than 1% under the above operation condition. To simplify the audio system design in the notebook application and to enlarge the driving power, CXAR41277 supports the Bridge-Tied Load (BTL) mode for driving the speakers. For the low current consumption applications, the SHDN mode is supported to disable CXAR41277 when it is idle. The current consumption can be reduced to 150μA (typically). Amplifier gain is internally configured and controlled by two terminals (GAIN0, GAIN1). BTL gain settings of 6dB, 10dB, 15.6dB, 21.6dB are provided.
产品特点 返回TOP
„ Internal Gain Control, Which Eliminates External Gain-Setting Resistors „ Depop Circuitry Integrated
„ Output Power at 1% THD+N, VDD=5V
--2.0W/CH (typical) into a 4Ω Load
--1.2W/CH (typical) into a 8Ω Load
„ Bridge-Tied Load (BTL) Supported
„ Fully differential Input
„ Shutdown Control Available
„ Surface-Mount Power Package
„ Over-Temperature Protection Embedded 20-Pin TSSOP-P & 20-Pin TQFN 4X4
应用范围 返回TOP
„ Stereo Power Amplifiers for Notebooks or Desktop Computers
„ Multimedia Monitors
„ Stereo Power Amplifiers for Portable Audio Systems
技术规格书（产品PDF) 返回TOP
需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！
产品封装图 返回TOP
电路原理图 返回TOP
a
相关芯片选择指南 返回TOP 更多同类产品。。。。。。。
|
Stereo Audio Amplifier |
|||||||||
|
Part NO. |
VDD (V) min |
VDD (V) max |
POUT THD=1% (W,Ohm) |
POUT(mW) THD=10% (W,Ohm) |
PSRR (dB) |
Gain setting |
Enable Active |
Note |
Package |
|
4.5 |
5.5 |
2.0, 4 |
2.5, 4 |
68 |
Fixed/ADJ |
High |
BTL, De-pop |
TSSOP-20(FD) |
|
|
-- |
6 |
2.0, 4 |
2.6, 4 |
65 |
ADJ |
Low/High |
BTL, Mute, De-pop, POUT(max) Clamping |
TSSOP-24(FD)/ QFN4X4-24 |
|
|
3 |
5.5 |
1.2, 4 |
2.0, 4 |
68 |
Fixed/ADJ |
Low |
DC volume control, PC-Beep |
TSSOP-28(FD)/ TQFN5X5-28 |
|
|
4.5 |
5.5 |
1.9, 4 |
2.6, 4 |
50 |
Fixed |
High |
BTL, SE, OTP |
SOP-16(FD) |
|
|
3 |
5.5 |
1.5, 4 |
2.1, 3 |
-- |
ADJ |
Low/High |
BTL, De-pop |
TQFN3X3-16 |
|
◀ 上一篇:CXAR41276单声道D类音频功率放大器在5V电源电压驱动2W连续均方根功率以桥连负载BTL方式进入4Ω负载Depop电路集成 2.8V至5.5V操作
下一篇▶:CXAR41278立体声音频功率放大器驱动2.0W的连续有效值电源在5V电源电压下桥接负载BTL模式每个通道4Ω负载立体声输入多路复用器静音和关机控制输出功率钳位功能
| 热门信息 |
|---|
| 最新信息 |
|---|
| 推荐信息 |
|---|
| 相关文章 |
|---|
| 无相关信息 |
