CXEP2330 is a high-accuracy analog front-end (AFE) IC that provides measurements for four-quadrant 3-phase metering. The combination of a 21-bit sigma-delta analog-to-digital converter with a six-inpu

   产品概述 返回TOPTxy嘉泰姆

The CXEP2330 is a high-accuracy analog front-end (AFE) IC that provides measurements for four-quadrant 3-phase metering. The combination of a 21-bit sigma-delta analog-to-digital converter with a six-input AFE, a thermally compensated high-precision reference, and a compute engine results in high accuracy and wide dynamic range. Our Single Converter Technology reduces crosstalk and cost. This IC also provides a real-time clock (RTC) and battery backup for time-of-use (TOU) metering.The host processor communicates with the CXEP2330 through a UART interface using the programmable IRQZ interrupt. The CXEP2330 calculates and accumulates meter measurements for each accumulation interval. A high-speed synchronous serial port (SSI) is provided to facilitate high-end metering.  Integrated rectifying functions on the battery-backup circuit enable minimal external component usage and minimum backup current. Also, eight multipurpose pins are provided for control of peripherals.

   产品特点 返回TOPTxy嘉泰姆

High Accuracy Txy嘉泰姆

 < 0.1% Wh accuracy over 2000:1 range Txy嘉泰姆

 Exceeds IEC 62053/ANSIC 12.20 specifications Txy嘉泰姆

 Up to 10ppm/Txy嘉泰姆

C precision ultra-stable voltage reference Txy嘉泰姆

 Single Converter Technology reduces cross talk and power consumption Txy嘉泰姆

 Six sensor inputs—referenced to V3P3 Txy嘉泰姆

 Compatible with CTs, resistive shunts and Rogowski Coil sensors Txy嘉泰姆

 Digital temperature compensation Txy嘉泰姆

 Sag detection Txy嘉泰姆

 Measures Wh, VARh, VAh, Vrms, Irms, V-to-V phase and load angle on each phase Txy嘉泰姆

 Four-quadrant metering. Txy嘉泰姆

 Four low-jitter pulse outputs from selectable measurements Txy嘉泰姆

 Four pulse count registers Txy嘉泰姆

 Selectable default status for pulse pins Txy嘉泰姆

 Same calibration data for 46Hz to 64Hz line frequency Txy嘉泰姆

 Broad CT phase compensation (±7deg) Battery Backup Txy嘉泰姆

 Powers real-time clock during power supply outage Txy嘉泰姆

 Compatible with Li-ion, NiCd, or super capacitor Txy嘉泰姆

 Battery backup current 2μA typical at 25°CTxy嘉泰姆

External Data Interface Txy嘉泰姆

 UART control interface, two selectable data rates Txy嘉泰姆

 8 general-purpose I/O pins with alarm capability Txy嘉泰姆

 5 or 10MHz selectable high-speed synchronous serial output for DSP interface Txy嘉泰姆

 IRQ output signal for alarms and end of measurement intervals Txy嘉泰姆

 Alarms on voltage sag, overvoltage, overcurrent Low System Cost Txy嘉泰姆

 Power consumption 30mW at 3.3V typical Txy嘉泰姆

 Real-time clock with temperature compensation Txy嘉泰姆

 Built-in power-fault detection Txy嘉泰姆

 Single 32kHz crystal time base Txy嘉泰姆

 Single-supply operation (3.3V)Txy嘉泰姆

 64-lead LQFP packageTxy嘉泰姆

   应用范围 返回TOPTxy嘉泰姆

Industrial, Commercial, and Residential MetersTxy嘉泰姆

   技术规格书（产品PDF) 返回TOP Txy嘉泰姆

     需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！
Txy嘉泰姆