2.7V至6V输入电压CXSU63138固定的开关频率1.5MHz电流模式N沟道MOSFET的升压调节器内置软启动

目录C1f嘉泰姆

1.产品概述                       2.产品特点C1f嘉泰姆
3.应用范围                       4.下载产品资料PDF文档 C1f嘉泰姆
5.产品封装图                     6.电路原理图                   C1f嘉泰姆
7.功能概述                        8.相关产品C1f嘉泰姆

一,产品概述(General Description)         C1f嘉泰姆

          The CXSU63138 is a fixed switching frequency (1.5MHz typical), current-mode,C1f嘉泰姆
step-up regulator with an inte-grated N-channel MOSFET. The device allows the usageC1f嘉泰姆
of small inductors and output capacitors for portable devices. The current-mode control C1f嘉泰姆

scheme provides fast transient response and good output voltage accuracy. The CXSU63138 includes under-voltage lockout, current-limit, and over-temperature shutdown preventing C1f嘉泰姆

dam-age in the event of an output overloadC1f嘉泰姆
二.产品特点(Features)C1f嘉泰姆

1.)Wide 2.7V to 6V Input Voltage RangeC1f嘉泰姆
2.)Built-in 0.2Ω N-Channel MOSFETC1f嘉泰姆
3.)Built-in Soft-StartC1f嘉泰姆
4.)High Efficiency up to 90%C1f嘉泰姆
5.)<1μA Quiescent Current During ShutdownC1f嘉泰姆
6.)Current-Mode OperationC1f嘉泰姆
    Stable with Ceramic Output CapacitorsC1f嘉泰姆
    Fast Transient ResponseC1f嘉泰姆
7.)Current-Limit ProtectionC1f嘉泰姆
8.)Over-Temperature Protection with HysteresisC1f嘉泰姆
9.)Available in a TSOT-23-5A and TDFN2x2-6 Pack-ageC1f嘉泰姆
10.)Lead Free and Green Devices Available(RoHS Compliant)C1f嘉泰姆
三,应用范围 (Applications)C1f嘉泰姆

Cell Phone and Smart PhoneC1f嘉泰姆
PDA, PMP, MP3C1f嘉泰姆
Digital CameraC1f嘉泰姆
Boost RegulatorsC1f嘉泰姆
四.下载产品资料PDF文档 C1f嘉泰姆

需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！C1f嘉泰姆

 C1f嘉泰姆

五,产品封装图 (Package)C1f嘉泰姆

C1f嘉泰姆

六.电路原理图C1f嘉泰姆

C1f嘉泰姆
C1f嘉泰姆

C1f嘉泰姆

七,功能概述C1f嘉泰姆

Main Control LoopC1f嘉泰姆
The CXSU63138 is a constant frequency and current-mode switching regulator. In normal operation, the internal C1f嘉泰姆

N-channel power MOSFET is turned on each cycle when the oscillator sets an internal RS latch,C1f嘉泰姆

 and then turned off when an internal comparator (ICMP) resets the latch. The peak inductor C1f嘉泰姆

current at which ICMP resets the RS latch is controlled by the voltage on the COMP node whichC1f嘉泰姆

is the output of the error amplifier (EAMP). An external resis-tive divider connected between C1f嘉泰姆

VOUT and ground allows the EAMP to receive an output feedback voltage VFB at FB pin. WhenC1f嘉泰姆

the load current increases, it causes a slightly to decrease in VFB associated with the 1.23VC1f嘉泰姆

reference,which in turn, it causes the COMP voltage to increase until the average inductor C1f嘉泰姆

current matches the new load current. C1f嘉泰姆

VIN Under-Voltage Lockout (UVLO)C1f嘉泰姆
The Under-Voltage Lockout (UVLO) circuit compares the input voltage at VIN with the UVLOC1f嘉泰姆

 threshold to ensure the input voltage is high enough for reliable operation.The 100mV (typ) C1f嘉泰姆

hysteresis prevents supply transients from causing a restart. Once the input voltage exceeds C1f嘉泰姆

the UVLO rising threshold, startup begins. When the in-put voltage falls below the UVLO fallingC1f嘉泰姆

 threshold, the controller turns off the converter.C1f嘉泰姆
Soft-StartC1f嘉泰姆
The CXSU63138 has a built-in soft-start to control the output voltage rise during start-up. During soft-start, anC1f嘉泰姆

 internal ramp voltage, connected to the one of the positive inputs of the error amplifier, raises up to replace the C1f嘉泰姆

reference voltage (1.23V typical) until the ramp voltage reaches the reference voltage.C1f嘉泰姆
Current-Limit ProtectionC1f嘉泰姆
The CXSU63138 monitors the inductor current, flows through the N-channel MOSFET, and limitsC1f嘉泰姆

 the current peak at current-limit level to prevent loads and the CXSU63138 from damaging during overload or C1f嘉泰姆

short-circuit conditions.C1f嘉泰姆

Over-Temperature Protection (OTP)C1f嘉泰姆
The over-temperature circuit limits the junction tempera-ture of the CXSU63138. When the C1f嘉泰姆

junction temperature  ex-ceeds 150 oC, a thermal sensor turns off the power MOSFET allowingC1f嘉泰姆

 the devices to cool. The thermal sen-sor allows the converters to start a soft-start process and C1f嘉泰姆

regulates the output voltage again after the junction tem-perature cools by 40oC. The OTP is designed C1f嘉泰姆

with a 40oC hysteresis to lower the average Junction Temperature (TJ) during continuous thermal overloadC1f嘉泰姆

 conditions in-creasing the lifetime of the device. C1f嘉泰姆

Enable/ShutdownC1f嘉泰姆
Driving EN to the ground places the CXSU63138 in shut-down mode. When in shutdown, the internal powerC1f嘉泰姆
MOSFET turns off, all internal circuitry shuts down, and the quiescent supply current reduces to 1μA maximum.C1f嘉泰姆
八,相关产品              更多同类产品......C1f嘉泰姆